Bigger stronger in segmented areas. Every LED engineering lamp belt brand company can meet all the needs of customers no matter how strong the resources, so it must be based on market segments, open up new categories, enter the "blue ocean" with little no competition, strive to meet the needs of Get the "new cake" by segmenting the customer's category needs.

     The assembly of led low-voltage light strips is divided into manual welding machine welding. Manual welding is to use a soldering iron use the original method for welding. The tip of the tin appears, which is typical of hand soldering. The products produced by this method of operation are ugly in appearance (inconsistent solder joint size, excessive flux residue, solder joints are smooth, the LED package is burned, etc.). Second, the electrostatic protection measures are good, many LED chips are broken. As a result, it appears slightly bright bright when power is applied.

LED driving power supply features: high reliability, especially like LED street light driving power supply, installed at high altitude, with waterproof aluminum case driving power supply, good quality is easy to break, reducing repairs High-power LED is an energy-saving product, the power of the driving power supply must be high. The structure of the power supply device in the luminaire is particularly important. Because the luminous power of an LED decreases as the temperature of the LED increases, the heat dissipation of the LED is very important. The power of the power supply is high, its power consumption is small, the amount of heat generated in the lamp is small, which reduces the temperature rise of the lamp. It is beneficial to delay the light decay of LED. High power factor Power factor is the load demand of the grid.

    Machine soldering is different. It is produced by SMT chip technology, solder paste reflow soldering process. Therefore, the solder joints on the low-voltage led strip are relatively smooth the amount of solder will be large. The solder joints are arc-shaped extend the FPC pad to the LED electrode. only the appearance of the product after soldering is beautiful (Smooth dots, no flux residue, LED package intact), the chip will be burned by static electricity. At the same time, the location orientation of the LED are relatively beautiful, so the difference in processing costs is also large.