LED light strip manufacturers briefly describe the future development of light strips

2019-12-24


  The "dawn" of emerging markets opens, the economic potential of the LED lighting industry is huge. China's LED lighting industry will usher in "emerging market opportunities". Once, as a large developing country, its semiconductor lighting products emerging markets are a natural match. Under the era of common development energy conservation low carbon, now is a good time for semiconductor lighting companies to enter emerging markets. Second, the government enterprises should now establish corresponding channels, financial market protection mechanisms, make full use of government policies, integrate related resources on the alliance platform, make lighting enterprises take root in emerging markets as soon as possible.


led灯带厂家

   

The power supply connection method of led strip manufacturers: LED strips generally have a DC 12V voltage, so it is necessary to use a switching power supply. The size of the power supply is determined by the power of the LED strip the connection length. If you do wish to use a power supply to control each LED light strip, you can adopt a switching power supply with a higher power ratio as the total power supply, then connect all the LED light strip input power sources in parallel. (Extended), unified power supply the main switching power supply. Such a benefit is that it can meet control, inconvenient places cannot achieve the lighting results switch control of a single LED strip. The specific method to be adopted can be weighed by itself.


    There are many types of light strips on the market, such as flat three-line, yuan second-line, flat four-line, led strips so on. Because LED light strip manufacturers have energy saving, environmental protection, long life, no pollution, economical. other advantages have occupied the main position of home improvement. Old-fashioned flat three-wire strips are only low in brightness but also large in power consumption, which have basically been eliminated. So when choosing a light strip, use a led light strip (light bead type is patch). LED light strips commonly used models are 3528 5050. (3528 refers to the size of the chip inside the light strip, which is a rectangle with a length of 3.2 width of 2.8 mm). 5050 light strip refers to the length width of the chip of the light strip are 5 mm. (Because the 5050 chip is much larger than the 3528 chip, the brightness of the 5050 is also about 70% higher than that of the 3528.)


分享到