Analysis on the characteristics of led low voltage light strip

    The two important components of LED strips, LED FPC, are products that cannot sustain high temperature. If the FPC is under continuous high temperature exceeds its withstand temperature, it will cause the cover film of the FPC to bubble, which will directly cause the LED strip to be scrapped. At the same time, LEDs can't sustain high temperature continuously, their chips will be burned out by high temperature if the temperature is long. The soldering iron used when repairing LED strips must use a temperature-controlled soldering iron to limit the temperature to a range, it is prohibited to change set it arbitrarily. Even so, it is also necessary to pay attention to the soldering iron to stay on the LED pin for more than 10 seconds during maintenance. If this time is exceeded, the LED chip may be burned out.

Indoor installation: When the low-voltage led strip is used for interior decoration, the installation is very simple because it does have to withstand wind rain. Take the LED strips produced by Guanghong Electronics as an example. The self-adhesive 3M double-sided tape is affixed to the back of each LED strip. When installing, you can directly remove the sticker on the surface of the 3M double-sided tape. For the installation place, just press flat with your hand. As for some places that need corners grow, what should I do? Quite simply, the LED light strip is a circuit structure composed of 3 LEDs in a series-parallel manner.

     Note the connection distance of led low-voltage light strips: Generally speaking, the connection length of 3528 series LED strips is 20 meters, the length of 5050 series LED strips is 15 meters. If this connection distance is exceeded, the LED light strip is easily heated, the service life of the LED light strip will be affected during use. Therefore, when installing, be sure to install it according to the manufacturer's requirements, do allow the LED lights to operate with overload.